Hammers and mallets are used to apply a striking force.
The carpenter’s hammer is used for driving and pulling nails and tapping wood chisels. |
Machinist’s ball peen hammers have a flat striking face for striking punches and chisels, and the other end is for forming soft metal, peening rivet heads, and striking metal in out-of-the-way plac |
The dead blow hammer is a shot-filled, rubber encased, single-piece hammer. It allows for greater striking power, and the elimination of broken heads and splintered handles. |
Sledge hammers have heavier heads and longer handles, and are used for striking punches and chisels, for breaking stones and concrete, and for setting timbers. |
The rubber mallet has a cylindrical rubber head. It is used for forming sheet metal, driving dowels, and small stakes. |
|
WEAR EYE PROTECTION AND WATCH THE FINGERS. BEFORE USING, CHECK FOR A LOOSE HEAD OR A CRACKED HANDLE. DO NOT USE HANDLE AS A PRY BAR, OR TO KNOCK SHARP EDGES TOGETHER.
References
Naval Education and Training Program. Tools and Their Uses. NAVEDTRA 14256, 1993.
http://www.hnsa.org/doc/pdf/tools.pdf